WinToFlash [The Bootable USB Creator]

Novicorp WinToFlash Forum

View unanswered posts | View active topics It is currently 25 Apr 2019, 15:04

Reply to topic  [ 1 post ] 
 hal.dll error 
Author Message

Joined: 17 Dec 2013, 15:34
Posts: 2
Reply with quote
Post hal.dll error

I have pre installed win 7 ultimate 32 bit,i know want add win xp as 2nd OS .Now i make usb bootable disk of 32 gb pen drive.
I change boot order of USB HARD DISK as 1st boot order.Now it gives me HAL.DLL error .What should i do .My boot.ini shows

[Boot Loader]
[Operating Systems]
C:\$WIN_NT$.~BT\BOOTSECT.DAT = "1st, text mode setup (Boot from flash again after finished)"
multi(0)disk(0)rdisk(1)partition(1)\WINDOWS="2nd, GUI mode setup, continue setup + 1st start of Windows" /fastdetect
C:\ = "---> DEBUG, in case of HAL.DLL or NTOSKRNL.EXE not found errors <---"
multi(0)disk(0)rdisk(1)partition(2)\WINDOWS="Debug boot rDisk 1 partition 2" /fastdetect
multi(0)disk(0)rdisk(1)partition(3)\WINDOWS="Debug boot rDisk 1 partition 3" /fastdetect
multi(0)disk(0)rdisk(1)partition(4)\WINDOWS="Debug boot rDisk 1 partition 4" /fastdetect
multi(0)disk(0)rdisk(2)partition(1)\WINDOWS="Debug boot rDisk 2 partition 1" /fastdetect
multi(0)disk(0)rdisk(2)partition(2)\WINDOWS="Debug boot rDisk 2 partition 2" /fastdetect
multi(0)disk(0)rdisk(2)partition(3)\WINDOWS="Debug boot rDisk 2 partition 3" /fastdetect
multi(0)disk(0)rdisk(2)partition(4)\WINDOWS="Debug boot rDisk 2 partition 4" /fastdetect

My laptop is compaq 420.

18 Dec 2013, 19:13
Report this post
Display posts from previous:  Sort by  
Reply to topic   [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 3 guests

You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum